Manual
The complete Handbook is still in draft statusThe loudspeakers' terminals
- Kind of TerminalsThe terminals can be either of gold plated brass or of gold plated copper.
- Single-Wire TerminalsThe rear panel of the loudspeaker has one only couple of terminals to feed both the woofer and the tweeter.
- Bi-Wire TerminalsThe rear panel of the loudspeaker has two couples of terminals to feed the woofer and the tweeter. This gives the possibility to connect to Your loudspeaker either in Bi-Wiring or in Bi-Amping setup.
• Bi-Wiring means that You can use 2 wires to connect the loudspeaker to Your power amplifier.
• Bi-Amping means that You can use 2 Power Amplifier to drive individually each of the loudspeaker component. - Safety InformationThere are some precautions to be kept in mind, read about them at the end of the page
- Show More
Gold plated brass Terminal
It is made by gold plated brass. It can host:
- 4mm banana plugs
- barbed wire
- spades
- 4mm banana plugs
- barbed wire
- spades
ETI Cable Pod Terminal
The Eichmann Cable Pods are one of the possible terminals that You might have installed on Your loudspeaker. Here You can find the manufacturer information.
The Eichmann Cable Pods have been developed with the goal to achieve the best possible signal transfer to the Loudspeakers. The constant section of 2,5mm2 is one of the key points.
It can host:
- 4mm banana plugs
- barbed wire
- spades
The Eichmann Cable Pods have been developed with the goal to achieve the best possible signal transfer to the Loudspeakers. The constant section of 2,5mm2 is one of the key points.
It can host:
- 4mm banana plugs
- barbed wire
- spades
Gold plated copper Terminal
The standard terminal for the Blumenhofer Acoustics loudspeaker. The main signal path is made of gold plated Tellurium Copper, designed on specification of Blumenhofer Acoustics. It can host:
- 4mm banana plugs
- barbed wire
- spades
- 4mm banana plugs
- barbed wire
- spades
Single-Wiring Terminal
Bi-Wiring Terminal
Important safety information
In some European countries, the use of 4mm banana plugs is considered a potential safety hazard: they may be inserted into the holes of unprotected power supply sockets. To comply with European CENELEC safety regulations, plastic pins block the 4mm holes in the ends of the terminals. Do not remove the pins if you are using the product where these conditions apply. Blumenhofer-Acoustics is not liable for improper use of the banana plugs.
Terminal with Banana protection
Terminal without Banana protection
